Overview
The Garmin 010-13915-00 is a replacement pull handle and cable kit for Force and Force Pro trolling motors.
This is the part you grab when you deploy, stow, and guide the motor on and off the mount. If the original handle is cracked or the cable coating is worn through, replacing it helps restore a secure grip and predictable handling at the ramp and dock.
Fit comes down to the trolling motor family, not the boat. Confirm you have a Force or Force Pro motor before ordering.
Key features
- Replacement pull handle and cable for Force and Force Pro trolling motors
- Plastic-coated braided cable for day-to-day handling and easier rinse-down
- Includes attachment hardware for installation
- Practical fix when the existing handle is damaged or the cable shows wear
Compatibility and fit
This kit is intended for Garmin Force and Force Pro trolling motors. It replaces the pull handle and cable assembly only, and it does not change shaft length, thrust, steering, or any electrical functions.
If your motor is not in the Force or Force Pro family, match the handle and cable style to your exact model before purchase.
Installation and setup
Support the trolling motor in the stowed position before removing the worn handle and cable. Install the new cable and handle using the supplied hardware, then cycle the deploy and stow motion by hand to confirm the cable runs freely and the handle clears the mount.
After the first outing, take a minute to re-check the connection points and look for any chafe spots where the cable might rub during normal use.
Maintenance and care
Rinse the handle and cable after trips that involve spray, sand, or salt. During routine checks, inspect the cable coating for nicks and the handle for looseness so you catch wear before it becomes a problem at the ramp.
What’s included
- Handle
- Plastic-coated braided cable
- Attachment hardware
- Documentation








Reviews
There are no reviews yet.